Louisiana Classic Truck Club

Just measure the height and tread width with a tape measure Eric, and the tire brand.

Ok Wynne.....the rear is Nexen Roadian HP 275/60/17 they are 29 1/2 tall and roughly 10 1/4" wide tread

Front are Federal Super Steel 595 255/55/17 they are 27 3/4" tall and thread is 8 1/4" wide roughly

Fronts or on 8" wheels and the rears or on 10" wheels


I hope that helps wynne...


Eric

Mike I need some rocker pics....any thing you have....i want to make sure its right before i go any futher....i am looking for where the doorbolts up and the seal plate goes......

Eric

Chevy_Man wrote:Ok Wynne.....the rear is Nexen Roadian HP 275/60/17 they are 29 1/2 tall and roughly 10 1/4" wide tread

Front are Federal Super Steel 595 255/55/17 they are 27 3/4" tall and thread is 8 1/4" wide roughly

Fronts or on 8" wheels and the rears or on 10" wheels


I hope that helps wynne...


Eric

Yeah that helps, Eric. I just want to compare it to what I have. Thanks

Eric,

See if these help, I'll dig around some more and see what I have. I'm on the way home tomorow, I should be at the house by 5.00. I'll be out of touch but catch me tonight and Ill dig around my memory sticks some more.

A couple more

Found a couple more, these are the best ones I have of the top. Wynne could probably snap you off a few, His has no carpet right now.

Thanks Mike ...that helps alot......what i was also looking for was how far down is the lip where the gasket goes from the floor where the seal plate sits once the carpet is in....


Eric

Well i have been working on mine.......i did some body work on the tail gate and spraying some high builds primer today......Cleaned the nos grill and put some primer to that thing and also the inner fenders.....I have also been sanding the inner side of the front fenders so i can put some primer to them also.......i will post a few pics tonight.....these rainy days help to get some of the easy stuff ready for water sanding.......

Eric

Here is what i was working on in the rain in the shop....

I also worked on the grill and the tail gate....the handle is shaved on the tail gate.....as i was putting the primer on wet i saw a 2 spots i am just not happy with......i may get me some gloss black rattle can and spray in the area that i am not happy with and stand the tail gate up as if it is on the truck and see if i can find my spots that way.... when it comes to stuff like that i am very anal......... if it was in a spot that was not looked at all the time i wouldn't worry about it......but here is a few pics....


Eric

This is what i plan to work on tomorrow........i have some body work to do on the cab corner that i changed.... and i am going to start the body work on the shaved fire wall......and finsh out a few items on the cab.......and sand and spray some primer......

Eric

Looks like you've got it going your way Eric!

Looking great Eric.

OK, you're making too much progress. I can bring my truck over there so you can replace rockers and cab corners, since it's still fresh in your mind.